All Hatch products are Special order.
If products is not available (back order item) usually ship between 4 to 6 weeks.

HATCH-SOGHK HATCH / HATCH Operator Hard Knuckle Glove 300-350-400

Sizes: S-XXL
Patented

SIZING
Use one of these methods to find your approximate glove size. Remember, no two hands are alike. Finger length relative to palm size is not constant from person to person. Additionally, what constitutes a comfortable fit can vary considerably between individuals. Using one of the methods below will help you to find an approximate glove size, but no method of measurement can substitute for actually trying them on.
SIZING CHART
MEASUREMENT GLOVE SIZE
7" (17.8cm) X-SMALL
8" (20cm) SMALL
9" (23cm) MEDIUM
10" (25cm) LARGE
11" (28cm) X-LARGE
12" (30.5cm) XX-LARGE
13" (33cm) XXX-LARGE

USING A TAPE MEASURE AND THE SIZING GUIDE (MORE ACCURATE)
Wrap a tape measure around your hand at the widest point (usually the knuckles) and make a loose fist. Note that measurement, round it to the nearest inch and refer to the chart above to find your approximate glove size.

USING THE SIZING GAUGE

Hatch gloves are designed and manufactured with the highest quality materials. To provide you with years of use, please follow these care and maintenance instructions.

CLEANING/MAINTENANCE
Both new and used gloves should be thoroughly inspected before wearing to ensure no damage is present. After each use, where re-use is intended, contaminated gloves should be cleaned. All Hatch gloves should be hand-washed and air-dried.

Leather Gloves
If your gloves become soiled they may be washed with mild soap (preferably anti-bacterial) and warm (not hot) water. Wash them separately from other garments, as some of the dye may not have the same stability as other clothing. Rinse thoroughly with cold water, pat dry with a towel and allow to air dry completely. Do not machine dry. Washing your gloves will take some of the natural oils out of the leather, therefore they should be reconditioned. For best results, use a leather conditioner. If you prefer, regular hair conditioner is an inexpensive, viable substitute.

To wash BG800 Guardian™ bloodborne pathogen protective gloves, do not submerse in water, but wipe them off instead to avoid contaminating or damaging the liners. To disinfect the leather, a 10:1 water/bleach solution should be used, as recommended by both the Environmental Protection Agency and Fabric Care Institute. This should be applied using a cloth or cotton balls. Rinse, dry and recondition the leather as directed above.

*Note: Allowing the bleach solution into the inside of the BG800 will compromise the integrity of the liners. Should blood or other body fluids enter the inside of your gloves, discard them immediately.

KEVLAR® Apparel
The following instructions are for washing KEVLAR® fabric only. Keep this in mind when laundering Hatch products containing other materials in addition to KEVLAR®. All Hatch gloves should be hand-washed and air-dried.

Your KEVLAR® apparel should be kept clean to eliminate contamination from any other chemicals or fibers, which may compromise the flame resistant characteristics. Paint, oils and other flammable chemicals can pose a significant hazard if they are not removed from the garment.

Garments of KEVLAR® should be washed separately from other articles. This will help prevent contamination of lint from other fibers, which may be flammable.

STORAGE
Gloves should ideally be stored in dry conditions in the original package.

OBSOLESCENCE
When stored as recommended, gloves will not suffer change in mechanical properties for up to three years from the date of manufacture. Service life cannot be specified and depends upon the application. It is the responsibility of the user to ascertain suitability of gloves for its intended use.

HATCH-SOGHK【HATCH/
HATCH Operator Hard Knuckle Glove 300-350-400】AXTOriginalDetaildImages